Here is the original blog post over at Lumberjocks.com
Got the clamps off and now it’s time to clean up the glue joints and prep the surfaces for finish.
First thing to do was remove the clamps, flip the bench on it’s side, and plane all of the joints even.
Image may be NSFW.
Clik here to view.
After leveling the divider joints next came the ends. Bringing the half blind dovetails and through mortises level.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
After the the ends and sides were level and smooth I ran around all of the corners, exterior and interior, with a hand held router and an eighth inch round over bit.
Image may be NSFW.
Clik here to view.
After that it was planing the seat smooth as glass.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
